9
Installing the Skid Plate
Kubota Engine Only
Parts needed for this procedure:
1
Skid plate
2
Bolt (3/8 x 1-1/4 inches)
2
Bolt (3/8 x 1 inch)
4
Flange nut (3/8 inch)
Procedure
Use the bolt (3/8 x 1-1/4 inches), (3/8 x 1 inch), and
nuts to secure the skid plate to the frame
Figure 45
1. Bolt (3/8 x 1-1/4 inches)
2. Skid plate
(Figure
45).
g032568
3. Bolt (3/8 x 1 inch)
4. Flange nut (3/8 inch)
10
Removing the Roll Bar
No Parts Required
Procedure
Note:
Have another person help you remove the roll
bar from the machine.
1.
Have another person support the roll bar.
2.
Remove the hairpins and the pivot-lock pins
from the roll bar and set the hairpins aside
(Figure
46).
1. Pivot bolt
2. Lanyard washer
3. Roll bar
3.
Remove the pivot bolt and lanyard washer.
4.
Remove the roll bar from the machine.
5.
Store the roll bar.
Note:
Retain or loosely install the hardware that you
removed during this procedure so that it is available
for seasonal changeover.
26
Figure 46
4. Pivot-lock pin
5. Lower-ROPS pin
6. Hairpin
g032775