Table of Contents
Advertisement
11
Removing the Summer
Frame
Parts needed for this procedure:
2
Roller assembly
1
Left bracket
1
Right bracket
2
Bolt (3/8 x 2-1/4 inches)
2
Bolt (3/8 x 5/8 inch)
4
Flange nut (3/8 inch)
2
Clevis pin
2
Self-tapping screw (1/4 inch)
2
Hose plugs
Installing the Conversion Rollers
1.
Use a floor jack to lift the rear wheels off the
ground and support them with a jack stand.
2.
On machines that have a serial number less
than 312999999, install the vertical tube support
assembly to each rear corner of the deck frame
with a clevis pin and a self-tapping screw (1/4
inch)
(Figure
47).
Figure 47
1. Deck frame
2. Self-tapping screw (1/4
inch)
3.
On traction units that have a serial number
greater than 313000001, install a conversion
bracket (right or left hand) to the under-side of
g024844
3. Clevis pin
4. Roller assembly
the appropriate rear corner of the deck frame
with a self-tapping screw (3/8 x 5/8 inch)
48).
Note:
Point the bracket toward the end of the
rear frame.
1. Deck frame
2. Flange nut
3. Conversion bracket
4. Screw
4.
Install the roller assembly to each conversion
bracket with a bolt (3/8 x 2-1/4 inches) and
flange nut
(Figure
Removing the Operator Platform
1.
Tilt the operator platform into its latched position
(Figure
49).
1. Operator platform
27
Figure 48
5. Self-tapping screw
6. Roller assembly
7. Self-tapping screw
48).
Figure 49
(Figure
g024845
g032441
Advertisement
Table of Contents
