Toro Polar Trac Cab 30474 Operator's Manual page 29

2. Use 2 jack stand underneath the frame to
support the back of the machine
Figure 54
Kubota frame shown
1. Jack stand
3. Place a suitable drain pan underneath the valve
and disconnect the hydraulic hoses from the
control valve (Figure
Figure 55
1. Hydraulic-return hose
4. Disconnect the 2 connectors plugged into the
control valve and coil them up, and store them
inside the control box until the next changeover.
5. Install the caps from the winter valve kit into the
control valve fitting and plug the hoses with the
plugs supplied.
Note:
Clean-up any hydraulic fluid that spilled.
6. Remove the retaining ring, remove the bolt
securing the pivot pin, and remove the pivot pin
to allow you move the cylinder out of the way.
(Figure 54).
2. Frame
55).
2. Hydraulic-supply hose
g032569
1. Retaining ring
2. Lift cylinder
7. Remove the locknuts and bolts securing the
summer frame to the machine frame (
57 and Figure
g032445
1. Locknut
2. Bolt
29
Figure 56
3. Bolt
4. Pivot pin
58).
Figure 57
3. Bolt
g032735
Figure
g032444