Table of Contents
Advertisement
Figure 90
1. Track path
8.
Install the front wheels to the winter frame; refer
to
Installing the Wheels (page
9.
Use a floor jack to remove the jack stands and
lower the machine to the ground.
10.
Install the locknut and washer to the threaded
stud on the bogie-stop assembly
Figure 91
1. Locknut
2. Washer
11.
Torque the nut to 91 to 113 N∙m (67 to 83 ft-lb).
g032739
2. Track
38).
(Figure
91).
g032573
3. Threaded stud
4. Bogie-stop assembly
14
Completing the Installation
No Parts Required
Procedure
1.
Install the hood on to the machine.
2.
Fill the washer fluid tank.
3.
Fill the radiator; refer to the machine Operator's
Manual for fluid specifications.
4.
Check the hydraulic-fluid level and replenish as
needed; refer to the machine Operator's Manual
for the hydraulic fluid specification.
5.
Connect the negative (-) battery cable to the
battery.
6.
Start the machine, raise and lower the lift arm,
and check for hydraulic leaks.
7.
Check the hydraulic fluid and coolant levels
again and add hydraulic fluid and coolant as
needed.
8.
Store the summer frame, components, and
hardware until the next seasonal changeover.
40
Advertisement
Table of Contents
