Table of Contents
Advertisement
4.
Use the coupler link, bolt (3/4 x 4 inches),
and washer to secure the winter frame to the
machine frame
(Figure
1. Coupler link
2. Washer (3/4 inch)
5.
Torque the bolt to 359 N∙m (265 ft-lb).
Securing the Cab to the Machine
1.
Alternate between turning the lift screws, a few
turns at a time to lower the back of the cab to
the machine
(Figure
1. Lift screw
2.
Use the bolt (1/2 x 3-1/4 inches) and (3/4 x 3-1/2
inches) to loosely install the cab-mount bracket
to each side of the ROPS tube
69).
Figure 69
3. Bolt (3/4 x 4 inches)
70).
Figure 70
(Figure
1. Flange nut (1/2 inch)
2. Cab-bracket mount
3. Bolt (1/2 x 3-1/4 inches)
g032572
Note:
front of the machine.
3.
Insert a rubber isolator at each of the mounting
locations on the cab frame
1. Bolt (1/2 x 3-1/4 inches)
2. Large washer
3. Rubber isolator
g032783
4.
Use the bolt (1/2 x 3-1/4 inches), large washer
and flange nut to mount cab to the machine
(Figure
5.
Tighten the bolt (1/2 x 3-1/4 inches) until the
rubber isolator is compressed to a thickness of
22 mm (0.875 inch).
71).
6.
Tighten the bolts and nuts securing the
cab-mount supports to the ROPS posts
71).
34
Figure 71
4. Locknut (3/4 inch)
5. ROPS tube
6. Bolt (3/4 x 3-1/2 inches)
Point the cab-bracket mount toward the
(Figure
Figure 72
4. Cab frame
5. Cab-mount bracket
6. Flange nut (1/2 inch)
72).
g032662
72).
g032784
(Figure
Advertisement
Table of Contents
