Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
Description
No parts required
Rear-panel shield
Under-seat shield
Straight fitting (3/8 NPT x 0.625 barb)
Hose clamp (1/2 to 1-1/4 inches)
Hose clamp (3/4 to 1-1/2 inches)
Tee fitting
Female-dust fitting
Male-dust fitting
Grommet
Bulkhead bracket
Bolts (5/16 x 5/8 inch)
R-clamp
Carriage bolt (1/4 x 3/4 inch)
Flange nut (1/4 inch)
Hose clamp (1/2 to 1-1/4 inches)
Straight fitting (3/8 npt x 0.625 barb)
Temperature sensor (Yanmar engine
only)
Adapter (Yanmar engine only)
No parts required
Washer bottle
Bracket
R-clamp
Carriage bolt (5/16 x 1 inch)
Bolt (5/16 x 3/4 inch)
Flange nut (5/16 inch)
Carriage bolt (1/4 x 3/4 inch)
Nut (1/4 inch)
Wire harness
Relay
Fuse (60 A)
Fuse (10 A)
Cable tie
Wire harness fuse block—Toro Part No.
92-2641 (purchased separately)
Key start harness—Toro Part No.
107-0672 (purchased separately)
Skid plate
Bolt (3/8 x 1-1/4 inches)
Bolt (3/8 x 1 inch)
Flange nut (3/8 inch)
Qty.
Prepare the machine for installing the
–
kit.
1
Install the heat shields.
1
1
4
1
Assemble the heater hoses.
1
1
1
1
1
2
Install the bulkhead bracket.
2
2
2
1
1
Route the heater hose.
1
1
–
Install the temperature sensor.
1
1
1
3
Install the washer bottle.
2
5
1
1
1
1
1
2
Install the wire harness.
3
1
1
1
2
Install the skid plate.
2
4
7
Use