Table of Contents
Advertisement
Figure 5
1. Seat connector
2. Wire harness
3.
Remove the wire clip from the bottom of the seat
deck
Figure
5.
4.
Clean the bottom of the seat deck to ensure
proper adhesion of the under-seat shield.
5.
Remove the backing and apply the under-seat
shield to the bottom of the seat deck
Figure 6
1. Heat shield
g032391
3. Wire clip
(Figure
g032392
2. Cutout
Note:
Use the cutouts for the bolts to align the
under-seat shield to the plate.
6.
Install the wire clip to the bottom of the seat
plate
(Figure
1. Hole for wire clip
7.
Connect the seat-switch to the wire harness
(Figure
7).
3
6).
Assembling the Heater
Hoses
Parts needed for this procedure:
1
Straight fitting (3/8 NPT x 0.625 barb)
4
Hose clamp (1/2 to 1-1/4 inches)
1
Hose clamp (3/4 to 1-1/2 inches)
1
Tee fitting
1
Female-dust fitting
1
Male-dust fitting
Assembling the Supply Hose
Note:
Use the 86.3 cm (34 inches) hose for a
machine equipped with the Yanmar engine and
use the 57.1 cm (22.5 inches) hose for a machine
equipped with the Kubota engine.
1.
Apply sealant to the straight fitting (3/8 NPT x
0.625 barb); skipping the first thread.
10
7).
Figure 7
2. Wire clip
g032393
Advertisement
Table of Contents
