Toro Polar Trac Cab 30474 Operator's Manual page 23

Routing the Wire Harness
Yanmar Only
1. Route the 3 cab connectors through the
grommet (Figure
Figure 39
1. Cab connectors
2. Relay assembly
3. Fuse assembly (60 A)
4. Fuse holder
2. Route the auxiliary-power wire across the frame
support, down along the ROPS tube, and toward
the operator controls
3. Route the washer wire across the frame support,
down along the ROPS tube, and toward the
washer bottle (Figure
4. Use the cable ties to secure the wire harness
to the frame.
Note:
Do not secure the wire harness to hot or
moving parts.
39).
5. Positive connector (red)
6. Negative connector (black)
7. Washer-bottle connector
8. Auxiliary-power wire
(Figure 39).
39).
Connecting the Auxiliary-Power
Wire—Fuse Block of the Machine
Note:
If you do not have an open slot in the fuse
block for the machine, skip to
Auxiliary-Power Wire—Additional Wire Harness Fuse
Block (page 24).
1. Toggle the swell latches and open the
operator-controls compartment
g032516
1. Swell latch
2. Route the auxiliary-power wire (green color
insulation) of the wire harness (kit) into the
operator-controls compartment
1. Insulated blade connector
(auxiliary-power
wire—green)
2. Insulated socket connector
(fuse-block wire—pink)
3. Fuse block
23
Connecting the
(Figure
Figure 40
(Figure
Figure 41
4. Fuse (10 A)
5. Fuse (2 A)—if installed
40).
g032521
41).
g233782