Toro Polar Trac Cab 30474 Operator's Manual page 32

7. Press the forward edge of the side front foam
seal into the front foam seal and align the inner
edges of the foam seal with the inner edges of
the seal panels of the cab frame
Figure 63
1. Side, front foam seal
Mounting the Cab to the Winter
Frame
1. Use the 4 lift points to support the cab above
the machine (Figure
Figure 64
1. Hoist bar
2. Front-lift point
Note:
Ensure that the lifting tool does
not contact the cab roof or headliner when
supporting the cab.
2. Lower the cab to the machine aligning the 2 bolt
holes on the front mounts
(Figure 63).
2. Front foam seal
64).
3. Rear-lift point
(Figure 65).
g028728
1. Lower mount
2. Bolt (1/2 x 3-1/4 inches)
3. Washer (1/2 inch)
4. Upper mount
3. Insert a rubber isolator at each of the mounting
locations
4. Use the bolt (1/2 x 3-1/4 inches), large washer
and flange nut to mount cab to the machine
(Figure 65).
5. Tighten the bolt (1/2 x 3-1/4 inches) until you
compress the rubber to a thickness of 22 mm
(0.875 inch).
g030873
32
Figure 65
5. Flange nut (1/2 inch)
6. Large washer
7. Rubber isolator
(Figure 65).
g032780