Table of Contents
Advertisement
4
Installing the Bulkhead
Bracket
Parts needed for this procedure:
1
Grommet
1
Bulkhead bracket
2
Bolts (5/16 x 5/8 inch)
2
R-clamp
2
Carriage bolt (1/4 x 3/4 inch)
2
Flange nut (1/4 inch)
Installing the Grommet
Note:
If the grommets are not installed, perform this
procedure.
1.
Remove the caps covering the holes in the
support tube
(Figure
Figure 14
1. Cap
9).
2.
If it is present, remove the punch-out located
between the 2 holes
1. Punch-out
Note:
If necessary, use a metal-cutting tool to
remove the material between the 2 holes in the
support tube.
3.
Install the grommet into the opening
g234097
1. Grommet
Installing the Hose Bracket
1.
Use the 2 bolts (5/16 x 5/8 inch) to install the
bracket to the frame
g032344
13
(Figure
15).
Figure 15
(Figure
Figure 16
(Figure
17).
g032345
16).
g032346
Advertisement
Table of Contents
