Table of Contents
Advertisement
1
Preparing the Machine
No Parts Required
Procedure
Note:
You can use a hoist for better access under
the machine.
Important:
Cap or plug any disconnected
hydraulic hoses, tubes, or component ports to
prevent contaminating the system.
1.
Park on a level surface, engage the parking
brake, ensure that the traction pedal is in the
neutral position.
2.
Ensure that the PTO button is in the O
position.
3.
Shut off the engine, remove the key, and allow
the machine to cool.
CAUTION
If you leave the key in the ignition
switch, someone could accidently start
the engine and seriously injure you or
bystanders.
Remove the key from the switch before
you do any maintenance.
4.
Bleed the pressure from the hydraulic system
by turning the hydraulic pump bypass valve;
refer to the instructions for pushing or towing the
machine in the Operator's Manual.
5.
If you are not installing the 4WD switch, skip
to
2 Removing the Hydraulic Lines (page
you are installing the 4WD switch, continue this
procedure.
6.
Open the right toolbox cover and disconnect the
negative cable from the battery post; refer to the
Operator's Manual for your machine.
WARNING
Incorrect battery-cable routing could
damage the machine and cables causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
7.
Disconnect the positive battery cable from the
battery; refer to the Operator's Manual for your
machine.
8.
Remove the right console cover as shown in
Figure
FF
4). If
1. Right toolbox cover
3
1.
Figure 1
2. Right console cover
g204998
Advertisement
Table of Contents
