Toro Polar Trac Cab 30474 Operator's Manual page 45

Disconnecting the PTO
1. Remove the 2 bolts securing the floor-plate
cover and remove the cover
Figure 101
1. Bolt
2. Remove the roll pin and loosen the 2 bolts
securing the drive shaft to the gearbox shaft
(Figure 102).
Figure 102
1. PTO shaft
2. Bolt
3. PTO yolk
3. Set aside the roll pin.
(Figure 101).
g032576
2. Operator deck
g032627
4. Locknut
5. Roll pin
Removing the Tracks
1. Place 2 jack stands underneath the back of
machine frame
1. Machine frame
2. Remove the locknut and washer from the
threaded stud on the bogie-stop assembly
(Figure 104).
1. Locknut
2. Washer
3. Position a floor jack under the pivot point for the
attachment assembly and raise the front of the
frame until the center wheels swing back, nearly
contacting the rear wheels
45
(Figure 103).
Figure 103
2. Jack stand
Figure 104
3. Threaded stud
4. Bogie-stop assembly
(Figure 105).
g032669
g032573