Toro Polar Trac Cab 30474 Operator's Manual page 25

Component Wire color
Key start harness Blue (18 gauge)
(Part No.
107-0672)
Polar Trac kit
Green (18
harness gauge—cab enable
power)
5. Install the fuse (10 A) into the fuse-block slot
(Figure 42).
6. Use the cable ties to secure the wire.
Note:
Do not secure the wire harness to hot or
moving parts.
Connecting the Washer Bottle
1. Connect the plug into the washer bottle
43).
Figure 43
1. Washer connector
2. Use the cable ties to secure the wire harness
to the frame.
Note:
Do not secure the wire harness to hot or
moving parts.
Connector type
Insulated socket
connector
Uninsulated blade
connector
(Figure
g032522
2. Washer-bottle connection
Connecting the Battery
1. Route the 10-gauge red and black wires along
the ROPS tube on the left side of the frame and
toward the battery
2. Loosen and remove the negative-post clamp
and then the positive-post clamp from the
battery (Figure
1. Positive-post clamp
2. Negative-post clamp
3. Nut
3. Remove the nuts from the post bolts
4. Install the negative-terminal connector (black
wire) over the negative-post bolt and loosely
install the nut
5. Install the positive-terminal connector (red wire)
over the positive-post bolt and loosely install the
nut (Figure 44).
6. Install the positive-post clamp to the
positive-battery post and then the negative-post
clamp to the negative-battery post
7. Use the cable ties to secure the wire harness
to the frame.
Note:
Do not secure the wire harness to hot or
moving parts.
25
(Figure 38).
44).
Figure 44
4. Ring connector
5. Bolt
(Figure 44).
(Figure
g032519
(Figure 44).
44).