Toro Polar Trac Cab 30474 Operator's Manual page 35

•
Torque the bolts (1/2 x 3-1/4 inches) to 91 to
113 N∙m (67 to 83 ft-lb).
•
Torque the bolts (3/4 x 3-1/2 inches) to 322
to 396 N∙m (238 to 292 ft-lb).
7. Remove the lift-bar assembly and install the
access cover you set aside earlier
Routing and Connecting the
Hoses
1. Route the washer tube, heater-supply hose,
and heater-return hoses through the grommet
(Figure 73).
Figure 73
1. Washer tube
2. Heater-supply hose
2. Connect the washer tube, heater-supply hose,
and heater-return hose to its counterpart.
3. Route the drain hose through the grommet and
down the lower ROPS tube
4. Use cable ties to secure the drain hose to the
ROPS tube.
(Figure 66).
g032663
3. Heater-return hose
4. Drain tube
(Figure 73).
Connecting the Wire Harness
1. Route the wire harness from the cab toward the
wire harness from the machine
1. Machine wire harness
2. Connect the cab wire harness connectors to the
mating connector on the machine wire harness.
3. Use cable ties to secure the wires.
Note:
Do not secure the wire harness to hot or
moving parts.
35
(Figure
Figure 74
2. Cab wire harness
74).
g032664