Toro Polar Trac Cab 30474 Operator's Manual page 36

Installing the Rear Cover
1. Use the 5 bolts (3/8 x 3/4 inch) to secure the
rear cover to the machine
Figure 75
1. Rear cover
Note:
Install the center bolt first, then install the
remaining bolts.
2. Torque the bolts to 37 to 45 N∙m (27 to 33 ft-lb).
(Figure 75).
g234180
g032665
2. Bolt (3/8 x 3/4 inch)
Removing the Rear Wheels
1. Loosen the lug nuts on the rear wheels.
2. Use a floor jack to raise the rear wheels off the
ground and then support the frame with jack
stands (Figure
1. Jack stand
3. Remove the rear wheels from the machine.
4. Install the bolt (3/4 x 4 inches) as shown in
Figure 77.
1. Washer
5. Torque the bolt to 359 N∙m (265 ft-lb).
36
76).
Figure 76
2. Machine frame
Figure 77
2. Bolt (3/4 x 4 inches)
g032569
g032575