Storage
Storing the Machine
1.
Park the machine on a level surface, lower any
equipped attachments, shut off the engine, and
remove the key.
2.
Thoroughly clean the machine and cab, paying
special attention to these areas:
•
PTO shaft assembly
•
All grease fittings and pivot points
•
Oil the spline on the PTO output shaft to
prevent rusting
3.
Check and adjust the tire pressure; refer to
Checking the Tire Pressure (page
4.
Check all fasteners for looseness and tighten
them as necessary. Ensure that the 5 bolts that
secure the winter frame to the traction unit are
torqued to 359 N∙m (265 ft-lb).
5.
Grease or oil all grease fittings and pivot points
and wipe off any excess lubricant.
6.
Lightly sand and use touch up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
54).
56