Completing The Installation - Toro Reelmaster 33145 Operator's Manual

Figure 8
1. Drill a 1.59 cm (5/8 inch)
diameter hole here.
2. 6.35 cm (2-1/2 inches)
3. 2.2 cm (7/8 inch)
4. 5 cm (2 inches)
5. Drill a 13.5 cm (17/32 inch)
diameter hole here.
3. Secure the snap hook to the underside of the
frame with bolts and locknuts
4. Install the kit parts to the wing units by securing
the trailing hitch to the underside of the frame
with 2 bolts and locknuts
Note:
Before drilling, use the trailing hitch as a
template to verify the placement of the holes.
6. 1.9 cm (3/4 inch)
7. Trailing bar
8. Trailing unit
9. Hitch pin
10. Snap hook
(Figure 9).
(Figure 9).
1. Trailing hitch
2. Wing frame
3. 3.5 cm (1-3/8 inches)
g289161
5. Pull the entire trailing unit forward and insert the
bar under the 2 welded plates on the frame; pull
the unit back, snapping the hitch into the snap
hook.
4

Completing the Installation

Parts needed for this procedure:
1 Hitch extension
1 Hitch pin
1 Hairpin
Procedure
1. Attach the hitch extension to the machine with
the hitch pin and hairpin.
2. Drill mounting holes in the hitch extension to
accommodate the traction unit hitch.
3. Attach the machine to your traction unit; refer to
your traction unit Operator's Manual.
4. Lubricate all moving parts of the frame; refer to
Lubricating the Machine (page
8
Figure 9
4. 7 cm (2-3/4 inches)
5. Drill a 13.5 cm (17/32 inch)
diameter hole here.
6. 1.9 cm (3/4 inch)
12).
g289160