Table of Contents
Advertisement
dc_BA.boo Seite 74 Mittwoch, 20. Mai 2009 10:17 10
Safety
Occupant safety
Have seat belts replaced and their anchor-
ages checked if the belts have been dam-
aged or subjected to a heavy load in an
accident.
Work on the seat belts should always be car-
ried out at a qualified specialist workshop.
Mercedes-Benz recommends that you have
such work carried out at an SLR Service
Centre, since it has the specialist knowledge
and tools required for the work to be done.
In particular, work relevant to safety or on
safety-related systems must be carried out
at a qualified specialist workshop.
For safety reasons, Mercedes-Benz recom-
mends that you only use seat belts which
have been specially approved for your vehi-
cle by Mercedes-Benz.
74
SRS (Supplemental Restraint System)
The SRS consists of:
1 warning lamp
Belt tensioners
Belt force limiters
Airbag system with airbag control unit
and airbags
1 warning lamp
The SRS performs a self-test at regular in-
tervals when the ignition is switched on
and the engine is running. Malfunctions
can therefore be detected in good time.
The 1 warning lamp in the instrument
cluster ( page 43) comes on when you
switch on the ignition and goes out after a
delay of no more than a few seconds after
the engine is started.
Risk of injury
A malfunction has occurred if the
1
warning lamp:
does not come on when you switch on
the ignition
does not go out after a few seconds
when the engine is running
comes on again
G
Advertisement
Table of Contents
