Table of Contents
Advertisement
dc_BA.boo Seite 180 Mittwoch, 20. Mai 2009 10:17 10
Controls in detail
Features
Dust cover
Risk of injury
Allow the engine to cool down completely
before slipping the dust cover on your vehi-
cle. Otherwise, you could be seriously
burned when coming into contact with the
hot exhaust system.
The tonneaux has to be installed before
slipping on the dust cover ( page 186).
180
!
To avoid damage to the vehicle and the dust
cover, observe the following:
Use the dust cover only when the vehicle is
G
garaged.
Cover the vehicle only when the engine has
cooled down completely.
The vehicle as well as the dust cover must be
dry before slipping the dust cover on the ve-
hicle.
Make sure the dust cover is clean and dry
before inserting it in the bag provided with
the dust cover.
i
Clean the dust cover as follows:
wash at 40 °C
drip-dry (not tumble)
cool iron
Slipping dust cover on/off
Place the rolled-up dust cover with its
dark grey side facing downwards on
the vehicle roof.
The FRONT label is facing towards the
front of the vehicle.
Roll the side that is labelled FRONT
over the bonnet.
Roll the rear part over the tail end of
the vehicle.
Unfold the dust cover.
Advertisement
Table of Contents
