Nortel Communication Server 1000 Manual page 52

52 Basic configuration
Table 22
LD 14 Create channels within the service routes. (cont'd.)
Prompt Response
c u
DDSL
Group G
0-15
16-159
Group H
0-63
16-159
SIGL DAS
xx
CUST
....
0-511 1-4000
RTMB
0-127 1-4000
INC
(YES)
NO
PRIO (XHP)
YLP
Note:
applications, and should be set to 120 ohm impedance. For
more information on NT8D72BA switch settings, see DPNSS1
(NN43001-572). The NT5D97 also supports the EuroISDN applications.
Description
Format for CS 1000M Small System, Meridian 1 Small System,
CS 1000S system, Media Gateway 1000B, and Media Gateway
1000T, where c = card and u = unit.
The D-channel port number, entered in LD 17.
If the NT5K35 DCHI is used, or if the NT5K75 or NT6D11AE
DCHI is used and is set in normal mode;
If NT5K75 or NT6D11AE DCHI is set in expanded mode.
If the NT5K35 DCHI is used, or if the NT5K75 or NT6D11AE
DCHI is used and is set in normal mode;
If NT5K75 or NT6D11AE DCHI is set in expanded mode.
DASS2 channel
Customer number, as defined in LD 15
Route number and Member number
Range for Large System and CS 1000E system.
Range for CS 1000M Small System, Meridian 1 Small System,
CS 1000S system, Media Gateway 1000B, and Media Gateway
1000T.
Applies when creating members in data blocks.
If YES, channel numbers will be associated with members
starting at the TN, both channel and member numbers
increasing. If NO, member numbers decrease as channel
numbers increase.
High priority on channel seizure.
Low priority on channel seizure.
The high/low priority must be different at each end.
The NT8D72BA PRI card is required to support EuroISDN
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.