Nortel Communication Server 1000 Manual page 184

184 IDA status check and start-up
Table 102
DTM error messages (cont'd.)
Code Description
DTM342 n c p
Level 2 has detected a discrepancy in
the configuration of real channel c on
DTSL/DDSL n when a message was
sent from level 3; "p" indicates one of
the following problems:
0 — channel number out of range
1 — channel not configured
4 — channel not active
5 — li is incorrect
6 — already configured
7 — mi is out of range
DTM344 n c p
Level 2 has detected a discrepancy in
the configuration of real channel c on
DTSL/DDSL n when a message was
sent from level 3; "p" indicates one of
the following problems:
0 — channel number out of range
1 — channel not configured
2 — type (DASS2) is wrong
3 — side (A/B) is wrong
4 — channel is not active
DTM346 n c p
Level 3 has detected a discrepancy in
the configuration of real channel c on
DTSL/DDSL n when a message was
sent from level 2; "p" indicates one of
the following problems:
2 — type (DASS2) is wrong
3 — side (A/B) is wrong
DTM348 n All alarms cleared on DTSL/DDSL n
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Action
Check the state and configuration of
the channel.
Check the channel configuration at
the far end.
A DTM344 with a "p" = 3 is only
printed once after the STRT
command is assigned, when the
side of a DTSL is wrongly configured;
DTM334 messages with other values
for "p" printed every time that a
discrepancy is found.
Level 3 will attempt to update level 2.