Nortel Communication Server 1000 Manual page 51

Table 21
LD 16 Create service routes. (cont'd.)
Prompt Response
ROUT 0-511
0-127
TKTP IDA
SIGL
DPN
DAS
....
ICOG IAO
ICT
OGT
....
LID (0)-2
LCNO 0-255
....
DTOS (NO) YES
xxxx xxxx
TIDY
Table 22
LD 14 Create channels within the service routes.
Prompt Response
REQ NEW CHG
OUT PRT
END
TYPE RDC
TN
I s c u
Description
Route number
Range for Large System and CS 1000E system.
Range for CS 1000M Small System, Meridian 1 Small System,
CS 1000S system, Media Gateway 1000B, and Media Gateway
1000T.
The trunk type (DASS2).
Level 3 signaling.
Enter DAS for DASS2 signaling.
Defines the route as both incoming and outgoing.
Defines the route as incoming only.
Defines the route as outgoing only.
The option number for ISDN Line Identities. This is only
prompted if the IDC package is equipped.
0 - do not send
1 - send
2 - convert and send
The tree number to be used for converting Line Identities.
Enter YES if dial tone is required from the public exchange
when an outgoing DASS2 trunk is seized.
The Trunk Identity (that is, the four-digit PBX Reference
Number, followed by the four-digit Trunk Group Reference
Number.)
Description
Create new data base, modify existing data base, remove
data block, print data block, terminate program activity. NEW
and OUT may be followed by the number of channels being
initialized (1-30)
Real Digital Channel
Terminal Number
Format for Large System and CS 1000E system,
where l = loop, s = shelf, c = card, u = unit.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Configuring basic capabilities 51