Ida Trunk Maintenance Commands And Messages - Nortel Communication Server 1000 Manual

174 IDA status check and start-up
Table 93
DASS2 start-up (cont'd.)
Step Action
3
Enable the DCHI:
LD 75
ENL DDSL n
4
Enable the LAP protocols for each real
channel configured on the DASS2 link:
LD 75
STRT n
Both ends of the link should be started
within 5 minutes of each other.

IDA trunk maintenance commands and messages

IDA trunk maintenance is performed using LD 75.
maintenance commands available in LD 75" (page 174)
commands and status messages available in LD 75.
Table 94
IDA trunk maintenance commands available in LD 75
Command
ENL DDSL n
ENL DDCS l
ENL DTRC l c
DIS DDSL n
DIS DDCS l
DISI DDCS l
Description
Enable DCHI port n
Enable PRI loop l
Enable real channel (loop, channel)
Disable DCHI port n
Disable PRI loop n
Disable all channels on loop l as they become idle. The message
"OK DISABLING" is displayed and further commands may be
entered. Message DTM055 is displayed when all channels are
disabled.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Response
ENBL IDLE
(DCHI enabled, but all channels are
disabled)
ENBL STARTING
(the configured LAP protocols for each real
channel configured on the DASS2 link are
being enabled)
ENBL ACTIVE
(the configured LAP protocols for each real
channel configured on the DASS2 link are
enabled)
Table 94 "IDA trunk
is a general list of