Nortel Communication Server 1000 Manual page 183

Table 102
DTM error messages (cont'd.)
Code Description
DTM325 n DTSL/DDSL n is being reset
DTM326 n DTSL/DDSL n has been reset
DTM329 n c Channel is not in a state where it can
be reset
DTM330 n Invalid command for the state that
DTSL/DDSL n is in
DTM331 n Test message threshold has been
exceeded for DTSL/DDSL n
DTM332 n A level 3 to level 2 signaling test has
failed for DTSL/DDSL n
DTM335 n mi DTSL/DDSL n has failed to a
message sent to it; mi is the message
indicator code for the message
DTM336 n mi An attempt to send a message to
DTSL/DDSL n has failed; mi is the
message indicator code for the
message. Note: a spurious DTM335
is likely to follow
DTM337 n li mi Invalid input from DTSL/DDSL n;
l is the length indicator, mi is the
message indicator code for the
message
DTM338 n DTSL/DDSL n cannot be disabled
because the DTCS/DDCS is disabled
DTM339 n x Five minutes have elapsed since
DTSL/DDSL n was started and placed
in the active state; some channel
reset acknowledgements have bee
received, but "x" channels fail to start
DTM340 n Although DTSL/DDSL n is active
according to level 3, a report has
been received from level 2 indicating
the link is idle
DTM341 n Although DTSL/DDSL n is idle
according to level 3, a report has
been received from level 2 indicating
the link is starting or active
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Diagnostic error messages 183
Action
Check the DTSL status and re-enter
If fault persists, suspect a faulty DCHI
Link will be reset if this error persists
If issued after a command has been
entered, then repeat the command; If
error continues, suspect a faulty DCHI
DTCS(s) must be enabled first.
If fault persists, suspect a faulty
DCHI.
If fault persists, suspect a faulty
DCHI.