Nortel Communication Server 1000 Manual page 185

Table 102
DTM error messages (cont'd.)
Code Description
DTM350 Must switch reference clock before
disabling
for DTM310, DTM311, DTM312, and
DTM316 the alarm "z" is one of the
following code numbers:
0 — TBF (Transmit Buffer Full)
1 — FAE (Frame Alignment Error)
2 — HER (High Error Rate)
3 — TSF (Transmit Signal Failure)
4 — AIS (Alarm Indicator Signal)
5 — LOI (Loss of Input)
6 — DAI (Distant Alarm Indication)
Initialize (INI) error messages
When the system is initialized, all network cards are tested for read/write
response, and all DCHIs are tested for read/write response and stuck
interrupts.
If initialization follows a system reload or is manually invoked, then all links
are brought into service (resembling a link reset). If initialization occurs for
any other reason, then the links which are not disabled are reset. All calls
that were established before initialization are rebuilt. The error messages
described in
during system initialization.
Table 103
INI messages
Code
INI003 (fault codes 90 - 12F)
INI009 (fault codes 90 - 12F)
INI100
INI101
INI1006
Table 103 "INI messages" (page 185)
Description
Network card does not respond
The network card does not respond
DCHI does not respond from active CPU
DCHI does not respond from standby CPU
Unequipped card is responding
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Diagnostic error messages 185
Action
may be generated