Nortel Communication Server 1000 Manual page 37

—
•
one QPC775 Clock Controller (QPC775E is required on large systems,
and where EuroISDN functionalities are supported). This cable is
required if the DPNSS1 loop is to be used as a timing synchronization
source.
•
one NT8D79AD PRI to Clock Controller cable. This cable is required
if the DPNSS1 loop is to be used as a timing synchronization source
for the system PBX.
Note:
odd-numbered if the associated even-numbered loop is programmed
as being used for existing intelligent peripheral equipment, that is, as
TERM, TERD, or TERQ in LD 17. This constraint applies only when
Meridian Mail is equipped. Refer to
loops" (page
Table 12
Programming network loops
ENET Loop
Even
Odd
Engineering note pertaining to port addressing modes
There is a distinction between functionality regarding port addressing
modes in Group G and earlier, and Group H and later.
–
NTCK47AA Dual PRI to Clock Controller cable (2ft)
–
NTCK47AB Dual PRI to Clock Controller cable (4ft)
–
NTCK47AC Dual PRI to Clock Controller cable (6ft)
–
NTCK47AD Dual PRI to Clock Controller cable (8ft)
–
NTCK47AE/AF Dual PRI to Clock Controller cable (10ft)
Clock Controller Cables (1 to 4 port cables)
–
NTCK81AA Dual PRI to Clock Controller cable (2ft)
–
NTCK81AB Dual PRI to Clock Controller cable (4ft)
–
NTCK81AC Dual PRI to Clock Controller cable (6ft)
–
NTCK81AD Dual PRI to Clock Controller cable (8ft)
–
NTCK81AE/AF Dual PRI to Clock Controller cable (10ft)
Presently, the network loop used for DASS2 cannot be
37).
Allowed
Meridian PRI
Mail
Meridian PRI
Mail
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
DASS2 hardware requirements 37
Table 12 "Programming network
PRI Any
---
Meridian
Mail
Not Allowed
--- Meridian Mail
Any PRI