Nortel Communication Server 1000 Manual page 188

188 IDA status check and start-up
Input messages received by the software verify that the length is
consistent with the message type. A diagnostic message is generated for
any discrepancy.
188)
Table 108
Channel configuration error messages
Code
DTM342 n c p
DTM344 n c p
DTM346 n c p
Clock Controller (DTC) error messages (LD 60)
Table 109 "Clock controller status and error messages" (page
188)
LD 60 which indicate problems with the Clock Controllers.
Table 109
Clock controller status and error messages
Code Description
DTC001 Clock controller tracking on primary source loop.
DTC002 Clock controller tracking on secondary source loop.
Table 108 "Channel configuration error messages" (page
describes the channel configuration error messages.
Description
Level 2 has detected a discrepancy in the configuration of real
channel c on DTSL/DDSL n when a message was sent from level 3;
"p" indicates one of the following problems:
0 — channel number out of range
1 — channel not configured
4 — channel not active
5 — li is incorrect
6 — already configured
7 — mi is out of range
Level 2 has detected a discrepancy in the configuration of real
channel c on DTSL/DDSL n when a message was sent from level 3;
"p" indicates one of the following problems:
0 — channel number out of range
1 — channel not configured
2 — type (DASS2) is wrong
3 — side (A/B) is wrong
4 — channel is not active
Level 3 has detected a discrepancy in the configuration of real
channel c on DTSL/DDSL n when a message was sent from level 2;
"p" indicates one of the following problems:
2 — type (DASS2) is wrong
3 — side (A/B) is wrong
describes the Digital Trunk Clock Controller (DTC) error messages in
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.