Nortel Communication Server 1000 Manual page 182

182 IDA status check and start-up
Table 102
DTM error messages (cont'd.)
Code Description
DTM310 n z (see Alarm z has been detected by
note) DTSL/DDSL n and it has exceeded its
persistence limit
DTM311 n z (see Alarm z has been detected by
note) DTSL/DDSL n but has not exceeded
its persistence limit
DTM312 n z (see Alarm repeat count threshold has
note) been exceeded for alarm z on
DTSL/DDSL n
DTM313 n Stop count threshold has been
exceeded for DTSL/DDSL n
DTM314 n DTSL/DDSL n has been disabled
DTM315 n DTSL/DDSL n has failed to respond
to numerous "stop" messages and
therefore will be disabled instead
DTM316 n z Alarm z has been detected by
(see note) DTSL/DDSL n; DTSL/DDSL n is not
in the active state
DTM317 n DTSL/DDSL n does not respond
DTM318 n DTSL/DDSL n has been enabled
DTM319 n DTSL/DDSL n is about to be started
DTM320 n c Real channel c on DTSL/DDSL n
has failed to reset and remains in the
disabled state
DTM322 n c Real channel c on DTSL/DDSL n has
been reset
DTM324 n Channel reset threshold exceeded for
DTSL/DDSL n
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Action
Accompanied by a major alarm when
<alarm> = 1-5; accompanied by a
minor alarm when <alarm> = 6
Accompanied by a major alarm
Accompanied by a major alarm
May be accompanied by a major
alarm
Attempt a reset; If the fault persists,
suspect a faulty DCHI; accompanied
by a major alarm
Check switch settings on DCHI card
If multiple DTM320 messages occur,
then suspect one of the following:
link fault (check if an alarm is
present)
faulty DCHI
far end signaling card faulty
Suspect one of the following:
link fault (check if an alarm is
present)
faulty DCHI
far end signaling card faulty