Dass2 Hardware Requirements 79 - Nortel Communication Server 1000 Manual

is required if the DASS2 loop is to be used as a timing synchronization
source.
•
one NT8D79AD PRI to Clock Controller cable. This cable is required if
the DASS2 loop is to be used as a timing synchronization source.
•
one loop of the QPC414 ENET dual loop network interface card
•
for the NT5D97AD DPRI card, the following cables are used:
—
NTCK45AA 120 Ohm Dual PRI to I/O Panel cable (8ft)
—
NTCK79AA 75 Ohm Dual PRI Coax Cable (40ft)
—
NT8D7217 Dual PRI I/O Panel to Multiplexer cable (50ft)
—
NTCK46AA Dual PRI to DASS/DPNSS NT6D11 DCHI cable (6ft)
—
NTCK46AB Dual PRI to DASS/DPNSS NT6D11 DCHI cable (18ft)
—
NTCK46AC Dual PRI to DASS/DPNSS NT6D11 DCHI cable (35ft)
—
NTCK46AD Dual PRI to DASS/DPNSS NT6D11 DCHI cable (50ft)
—
Clock Controller cables (1 to 2 port cables):
–
NTCK47AA Dual PRI to Clock Controller cable (2ft)
–
NTCK47AB Dual PRI to Clock Controller cable (4ft)
–
NTCK47AC Dual PRI to Clock Controller cable (6ft)
–
NTCK47AD Dual PRI to Clock Controller cable (8ft)
–
NTCK47AE Dual PRI to Clock Controller cable (10ft)
—
Clock Controller Cables (1 to 4 port cables)
–
NTCK81AA Dual PRI to Clock Controller cable (2ft)
–
NTCK81AB Dual PRI to Clock Controller cable (4ft)
–
NTCK81AC Dual PRI to Clock Controller cable (6ft)
–
NTCK81AD Dual PRI to Clock Controller cable (8ft)
–
NTCK81AE Dual PRI to Clock Controller cable (10ft)
Note:
Presently, the network loop used for DASS2 cannot be
odd-numbered if the associated even-numbered loop is programmed
as being used for existing intelligent peripheral equipment, that is, as
TERM, TERD, or TERQ in LD17. This constraint applies only when
Meridian Mail is equipped. Refer to
loops" (page 80).
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.

DASS2 hardware requirements 79

Table 36 "Programming network