Nortel Communication Server 1000 Manual page 128

128 DCHI installation and removal
Figure 38
NT5K75 DIP switch settings
Port addressing modes
Port 0 Mode Selection
Port 0 is used to select whether the asynchronous ESDI port is be disabled
or not.
port 0 mode selection for the NT5K75.
Note:
Table 58
Port 0 mode selection for NT5K75
Port Mode
Not used
Asynchronous ESDI
Port disabled
Port 1 mode selection
Port 1 is used to select the standard or expanded D-channel addressing
mode on the NT5K75.
129)
Table 58 "Port 0 mode selection for NT5K75" (page 128)
The asynchronous ESDI port must be set to "disabled".
Table 59 "Port 1 mode selection for NT5K75" (page
describes port 1 mode selection for the NT5K75.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Switch Setting
SW1.1
0
1
1
describes
SW1.2
-
0
1