Nortel Communication Server 1000 Manual page 158

158 PRI installation and removal
Procedure 3
Installing the NT5D97AD
Step
1
2
3
4
5
6
7
8
9
10
11
12
13
CAUTION
The static discharge bracelet located inside the cabinet must be
worn before handling circuit cards. Failure to wear the bracelet
can result in damage to the circuit cards.
Action
Determine the cabinet and shelf location where the NT5D97AD
is to be installed. The NT5D97AD can be installed in any card
slot in the Network bus.
Unpack and inspect the NT5D97AD and cables.
If a DDCH is installed, refer to the section NTAG54 installation
and removal.
Set the option switches on the NT5D97AD card before
installation. Refer to
The ENB/DIS (enable/disable faceplate switch) must be
OFF (DIS) when installing the NT5D97AD, otherwise a
system initialize can occur. The ENB/DIS on the NT5D97AD
corresponds to the faceplate switch on the QPC414 Network
card.
Install NT5D97AD card in the assigned shelf and slot.
Set the ENB/DIS faceplate switch to ON. If the DDCH is
installed, the DDCH LED flashes three times.
If required, install the I/O adapters in the I/O panel.
Run and connect the NT5D97AD cables
CAUTION
Clock Controller cables connecting the Clock
Controller and NT5D97AD card must NOT be routed
through the center of the cabinet past the power
harness. Instead they should be routed around the
outside of the equipment shelves.
If required, install connecting blocks at the MDF or wall mounted
cross-connect terminal.
If required, designate connecting blocks at the MDF or wall
mounted cross-connect terminal.
If required, install a Network Channel Terminating Equipment
(NCTE) or Line Terminating Unit (LTU).
Add related office data into switch memory.
Enable faceplate switch S1. This is the "Loop Enable" switch.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
"NT5D97AD switch settings" (page 150).