Nortel Communication Server 1000 Manual page 133

The DIP switches are located as shown in
switch settings" (page
Figure 40
NT6D11AE/AF DIP switch settings
Port addressing modes
Port 0 Mode selection
Port 0 is used to select whether the asynchronous ESDI port is to be
disabled or not.
133)
Note:
Table 62
Port 0 mode selection for NT6D11AE/AF
Port Mode
Not used
Asynchronous ESDI
Port disabled
Port 1 mode selection
Port 1 is used to select the standard or expanded D-channel addressing
mode on the NT6D11AE/AF.
NT6D11AE/AF" (page 134)
NT6D11AE/AF.
133).
Table 62 "Port 0 mode selection for NT6D11AE/AF" (page
describes the port 0 mode selection for the NT6D11AE/AF.
The asynchronous ESDI port must be set to "disabled".
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Setting up the NT6D11AE/AF 133
Figure 40 "NT6D11AE/AF DIP
Switch Setting
SW1.1
0
1
1
Table 63 "Port 1 mode selection for
describes the port 1 mode selection for the
SW1.2
-
0
1