Nortel Communication Server 1000 Manual page 45

Table 14
LD 17 Configure DASS2 DCHI and PRI loop number up to and including Group G software, for
NT5K35, NT5K75, and NT6D11AE in standard mode. (cont'd.)
Prompt Response
.......
0-159
DDCS
Table 15
LD 17 Configure DASS2 DCHI and PRI loop number (if NT5K75 or NT6D11AE DCHI is used
in expanded mode)
Prompt Response
REQ CHG
TYPE CFN
.......
PARM YES
.......
DTIB 35-1000
DTOB 4-100
.......
CEQU YES
.......
DDCS 0-159
Table 16
LD 17 Configure DASS2 DCHI and PRI loop number.
Prompt Response
REQ CHG
TYPE CFN
0-63
ADAN
CTYP DCHI
Description
The PRI loop number for the new DASS2 link. Enter multiples
separated with a space.
Note: PRI loop numbers may have to be even values if the
adjacent loop on the network card is programmed.
Description
Modify existing data base.
Configuration data block.
To allow changes to the system buffers.
To define the number of trunk input buffers for the entire
system.
To define the number of trunk output buffers per DCHI.
To allow changes to the Common Equipment parameters.
The PRI loop number for the new DASS2 link. Enter multiples
separated with a space.
Note: PRI loop numbers may have to be even values if the
adjacent loop on the network card is programmed.
Description
Modify existing data base.
Configuration data block.
The DASS2 D-channel port number. This is a logical port
number, independent of the hardware I/O addresses. This
number is used to reference the D-channel in LD 74.
Selects the card type as being DCHI.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Configuring basic capabilities 45