Remote Node Filter; Figure 26-5 Menu 11.5: Remote Node Filter (Ethernet Encapsulation) - ZyXEL Communications Internet Security Gateway ZyWALL 2 Series User Manual

Table 26-4 Remote Node Network Layer Options Menu Fields
FIELD
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol used
to establish membership in a Multicast group. The ZyWALL supports both
IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2). Press [SPACE BAR]
to enable IP Multicasting or select None to disable it. See the LAN Setup
chapter for more information on this feature.
Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] at
the message "Press ENTER to Confirm..." to save your configuration and return to menu 11, or press [ESC]
at any time to cancel.

26.4 Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field.
For more information on defining the filters, please refer to the Filters chapter. For PPPoE or PPTP
encapsulation, you have the additional option of specifying remote node call filter sets.

Figure 26-5 Menu 11.5: Remote Node Filter (Ethernet Encapsulation)

Remote Node Setup
DESCRIPTION
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
ZyWALL 2 Series User's Guide
EXAMPLE
None
(default)
26-9