Figure 7-1 Rts Threshold - ZyXEL Communications Internet Security Gateway ZyWALL 2 Series User Manual

Internet security gateway
Hide thumbs Also See for Internet Security Gateway ZyWALL 2 Series:
Table of Contents

Advertisement

ZyWALL 2 Series User's Guide
is they do not know if the channel is currently being used. Therefore, they are considered hidden from each
other.
When station A sends data to the ZyWALL, it might not know that the station B is already using the channel.
If these two stations send data at the same time, collisions may occur when both sets of data arrive at the AP
at the same time, resulting in a loss of messages for both stations.
RTS/CTS is designed to prevent collisions due to hidden nodes. An RTS/CTS defines the biggest size data
frame you can send before an RTS (Request To Send)/CTS (Clear to Send) handshake is invoked.
When a data frame exceeds the RTS/CTS value you set (between 0 to 2432 bytes), the station that wants to
transmit this frame must first send an RTS (Request To Send) message to the AP for permission to send it.
The AP then responds with a CTS (Clear to Send) message to all other stations within its range to notify
them to defer their transmission. It also reserves and confirms with the requesting station the time frame for
the requested transmission.
Stations can send frames smaller than the specified RTS/CTS directly to the AP without the RTS (Request
To Send)/CTS (Clear to Send) handshake.
You should only configure RTS/CTS if the possibility of hidden nodes exists on your network and the "cost"
of resending large frames is more than the extra network overhead involved in the RTS (Request To
Send)/CTS (Clear to Send) handshake.
If the RTS/CTS value is greater than the Fragmentation Threshold value (see next), then the RTS (Request
To Send)/CTS (Clear to Send) handshake will never occur as data frames will be fragmented before they
reach RTS/CTS size.
Enabling the RTS Threshold causes redundant network overhead that could
negatively affect the throughput performance instead of providing a remedy.
7.2.4 Fragmentation Threshold
A Fragmentation Threshold is the maximum data fragment size (between 256 and 2432 bytes) that can be
sent in the wireless network before the ZyWALL will fragment the packet into smaller data frames.
7-2

Figure 7-1 RTS Threshold

A and B do not hear
each other. They
can hear the AP.
Wireless LAN Screens

Advertisement

Table of Contents
loading

Table of Contents