Snmp Traps; Table 31-2 Snmp Traps - ZyXEL Communications Internet Security Gateway ZyWALL 2 Series User Manual

ZyWALL 2 Series User's Guide
FIELD
Trap
Community
Destination
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC] to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

31.2 SNMP Traps

The ZyWALL will send traps to the SNMP manager when any one of the following events occurs:
TRAP #
0 coldStart (defined in RFC-1215)
1 warmStart (defined in RFC-1215)
4 authenticationFailure (defined in
RFC-1215)
6 whyReboot (defined in MIB)
6a For intentional reboot:
6b For fatal error:
31-2
Table 31-1 Menu 22: SNMP Configuration
Type the Trap community, which is the password sent with each
trap to the SNMP manager.
Type the IP address of the station to send your SNMP traps to.

Table 31-2 SNMP Traps

TRAP NAME
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent to the manager when receiving any SNMP
get or set requirements with the wrong community
(password).
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warm start).
A trap is sent with the message "System reboot by user!"
if reboot is done intentionally, (for example, download new
files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
DESCRIPTION
SNMP Configuration
EXAMPLE
Public
0.0.0.0