Figure 37-5 Menu 27.1.1.1: Ike Setup; Table 37-3 Menu 27.1.1.1: Ike Setup - ZyXEL Communications Internet Security Gateway ZyWALL 2 Series User Manual

ZyWALL 2 Series User's Guide
Press Space Bar to Toggle.
FIELD
Phase 1
Press [SPACE BAR] to choose from Main or Aggressive and then press
Negotiation
Mode [ENTER]. See earlier for a discussion of these modes. Multiple SAs
connecting through a secure gateway must have the same negotiation mode.
Authentication Press [SPACE BAR] to choose from PreShare Key or RSA SIG and then
Method press [ENTER].
PSK ZyWALL gateways authenticate an IKE VPN session by matching pre-shared
keys. Pre-shared keys are best for small networks with fewer than ten nodes.
Enter your pre-shared key here. Enter up to 31 characters. Any character may
be used, including spaces, but trailing spaces are truncated.
Both ends of the VPN tunnel must use the same pre-shared key. You will
receive a "PYLD_MALFORMED" (payload malformed) packet if the same pre-
shared key is not used on both ends.
Certificate Press [SPACE BAR] to choose the certificate to use for this VPN tunnel. You
must have certificates already configured in the My Certificates screen
37-12
Phase 1
Negotiation Mode= Main
Authentication Method= PreShare Key
PSK= qwer1234
Certificate= N/A
Encryption Algorithm= DES
Authentication Algorithm= MD5
SA Life Time (Seconds)= 300
Key Group= DH1
Phase 2
Active Protocol= ESP
Encryption Algorithm= DES
Authentication Algorithm= MD5
SA Life Time (Seconds)= 2880
Encapsulation= Tunnel
Perfect Forward Secrecy (PFS)= None
Press ENTER to Confirm or ESC to Cancel:
Figure 37-5
Table 37-3
Menu 27.1.1.1 - IKE Setup
Menu 27.1.1.1: IKE Setup
Menu 27.1.1.1: IKE Setup
DESCRIPTION EXAMPLE
Main
VPN/IPSec Setup