Remote Node Filter - ZyXEL Communications ZyAIR User Manual
Wireless gateway series
Hide thumbs
Also See for ZyAIR:
- Brochure & specs (11 pages) ,
- User manual (231 pages) ,
- Supplementary manual (1 page)
Table of Contents
Advertisement
ZyAIR Wireless Gateway Series User's Guide
Table 21-2 Menu 11.3 Remote Node Network Layer Options
FIELD
Network
Press [SPACE BAR] and then [ENTER] to select Full Feature if you
Address
have multiple public WAN IP addresses for your ZyAIR.
Translation
Select SUA Only if you have just one public WAN IP address for your
ZyAIR. The SMT uses Address Mapping Set 255 (menu 15.1 - see
section 23.2.1).
Select None to disable NAT.
Metric
The metric represents the "cost" of transmission for routing purposes.
IP routing uses hop count as the cost measurement, with a minimum of
1 for directly connected networks. Type a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
Private
This determines if the ZyAIR will include the route to this remote node
in its RIP broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
RIP Direction
Press [SPACE BAR] and then [ENTER] to select the RIP Direction.
Options are Both, In Only, Out Only or None.
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are RIP-1, RIP-2B or RIP-2M.
Multicast
IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and
None disables IGMP.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
21.2 Remote Node Filter
Move the cursor to the Edit Filter Sets field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER] to display Menu 11.5 - Remote Node Filter.
Use Menu 11.5 - Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the ZyAIR and also to prevent certain packets from triggering calls.
You can specify up to 4 filter sets separated by comma, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field.
21-6
DESCRIPTION
EXAMPLE
Full
Feature
No
None
RIP-1
None
Remote Node Configuration
2
Advertisement
Table of Contents
