Ike Setup - ZyXEL Communications Internet Security Gateway ZyWALL 2 Series User Manual
Internet security gateway
Hide thumbs
Also See for Internet Security Gateway ZyWALL 2 Series:
- User manual (686 pages) ,
- Quick start manual (137 pages) ,
- Firmware release notes (43 pages)
Table of Contents
Advertisement
FIELD
Port Start 0 is the default and signifies any port. Type a port number from 0 to 65535.
Someone behind the remote IPSec router cannot create a VPN tunnel
when attempting to connect using a port number that does not match this
port number or range of port numbers.
Some of the most common IP ports are: 21, FTP; 53, DNS; 23, Telnet; 80,
HTTP; 25, SMTP; 110, POP3.
End Enter a port number in this field to define a port range. This port number
must be greater than that specified in the previous field. This field is N/A
when 0 is configured in the Port Start field.
Enable Replay
As a VPN setup is processing intensive, the system is vulnerable to Denial
Detection
of Service (DoS) attacks The IPSec receiver can detect and reject old or
duplicate packets to protect against replay attacks. Enable replay detection
by setting this field to Yes.
Press [SPACE BAR] to select Yes or No. Choose Yes and press [ENTER]
to enable replay detection.
Key
Press [SPACE BAR] to choose either IKE or Manual and then press
Management
[ENTER]. Manual is useful for troubleshooting if you have problems using
IKE key management.
Edit Key
Press [SPACE BAR] to change the default No to Yes and then press
Management
[ENTER] to go to a key management menu for configuring your key
management setup (described later). If you set the Key Management field
Setup
to IKE, this will take you to Menu 27.1.1.1 – IKE Setup. If you set the Key
Management field to Manual, this will take you to Menu 27.1.1.2 –
Manual Setup.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
37.4 IKE Setup
To edit this menu, the Key Management field Menu 27.1.1 – IPSec Setup must be set to IKE. Move the
cursor to the Edit Key Management Setup field in Menu 27.1.1 – IPSec Setup; press [SPACE BAR] to
select Yes and then press [ENTER] to display Menu 27.1.1.1 – IKE Setup.
VPN/IPSec Setup
Table 37-2 Menu 27.1.1: IPSec Setup
DESCRIPTION
ZyWALL 2 Series User's Guide
EXAMPLE
0
No
IKE
No
37-11
Advertisement
Table of Contents
