Table 24-8 Menu 11.4: Remote Node Script Menu Fields
FIELD
Active
Press [SPACE BAR] and then [ENTER] to select either Yes to enable
the AT strings or No to disable them.
Set 1-6:
Enter an Expect string to match. After matching the Expect string, the
ZyWALL returns the string in the Send field.
Expect
Set 1-6:
Enter a string to send out after the Expect string is matched.
Send
24.10 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to four filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field.
Please refer to the Filters chapter for more information on defining the filters.
Figure 24-8 Menu 11.5: Dial Backup Remote Node Filter
WAN and Dial Backup Setup
DESCRIPTION
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
ZyWALL Series Internet Security Gateway
EXAMPLE
No
(default)
0.0.0.0
24-13