Figure 27-2 Menu 12. 1: Edit Ip Static Route; Table 27-1 Menu 12. 1: Edit Ip Static Route - ZyXEL Communications Internet Security Gateway ZyWALL 2 Series User Manual
Internet security gateway
Hide thumbs
Also See for Internet Security Gateway ZyWALL 2 Series:
- User manual (686 pages) ,
- Quick start manual (137 pages) ,
- Firmware release notes (43 pages)
Table of Contents
Advertisement
ZyWALL 2 Series User's Guide
`The following table describes the IP Static Route Menu fields.
FIELD
Route #
Route Name
Active
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Private
Once you have completed filling in this menu, press [ENTER] at the message "Press ENTER to
Confirm..." to save your configuration, or press [ESC] to cancel.
27-2
Figure 27-2 Menu 12. 1: Edit IP Static Route
Table 27-1 Menu 12. 1: Edit IP Static Route
This is the index number of the static route that you chose in menu 12.
Enter a descriptive name for this route. This is for identification purposes only.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the IP subnet mask for this destination.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
ZyWALL that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same segment as your ZyWALL; over the WAN, the gateway must
be the IP address of one of the remote nodes.
Enter a number from 1 to 15 to set this route's priority among the ZyWALL's routes
(see the Metric section in the WAN and Dial Backup Setup chapter). The smaller the
number, the higher priority the route has.
This parameter determines if the ZyWALL will include the route to this remote node in
its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP
broadcast. If No, the route to this remote node will be propagated to other hosts
through RIP broadcasts.
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
IP Static Route Setup
Advertisement
Table of Contents
