Remote Node Filter; Figure 5-6 Remote Node Filter (Ethernet Encapsulation) - ZyXEL Communications Prestige 314 PLUS User Manual

5.2.2 Editing TCP/IP Options (with PPPoE Encapsulation)
Make sure Encapsulation is set to PPPoE in menu 11.1. Move the cursor to the Edit IP field in menu 11.1.
The menu and filed are the same as described for PPTP encapsulation.
5.3

Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.1, then press the [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by commas, e.g., 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field. For
more information on defining the filters, please refer to the Filters chapter. For PPPoE or PPTP
Encapsulation, you can also specify remote node call filter sets.

Figure 5-6 Remote Node Filter (Ethernet Encapsulation)

Remote Node Setup
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 5
device filters=
Output Filter Sets:
protocol filters= 1
device filters=
Call Filter Sets:
protocol filters=1
device filters=
Enter here to CONFIRM or ESC to CANCEL:
5-11