Remote Node Filter; Figure 322 Menu 11.3.4: Remote Node Filter; Table 212 Menu 11.3.3: Remote Node Script - ZyXEL Communications ZyWall 5 Series User Manual

ZyWALL 5/35/70 Series User's Guide
The following table describes the fields in this menu.

Table 212 Menu 11.3.3: Remote Node Script

FIELD
Active
Set 1-6:
Expect
Set 1-6:
Send

34.10 Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.3, and then press [SPACE BAR] to
set the value to Yes. Press [ENTER] to open Menu 11.3.4 - Remote Node Filter.
Use menu 11.3.4 to specify the filter set(s) to apply to the incoming and outgoing traffic
between this remote node and the ZyWALL to prevent certain packets from triggering calls.
You can specify up to four filter sets separated by commas, for example, 1, 5, 9, 12, in each
filter field. Note that spaces are accepted in this field. Please refer to
for more information on defining the filters.

Figure 322 Menu 11.3.4: Remote Node Filter

574
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select either Yes to enable the AT strings or
No to disable them.
Enter an Expect string to match. After matching the Expect string, the ZyWALL returns
the string in the Send field.
Enter a string to send out after the Expect string is matched.
Menu 11.3.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Chapter 44 on page 633
Chapter 34 WAN and Dial Backup Setup