Table 33-3 General Commands For Gui-Based Tftp Clients - ZyXEL Communications Internet Security Gateway ZyWALL 2 Series User Manual

ZyWALL 2 User's Guide
TFTP client program. For UNIX, use "get" to transfer from the ZyWALL to the computer and "binary" to
set binary transfer mode.
33.3.7 TFTP Command Example
The following is an example TFTP command:
tftp [-i] host get rom-0 config.rom
Where "i" specifies binary image transfer mode (use this mode when transferring binary files), "host" is the
ZyWALL IP address, "get" transfers the file source on the ZyWALL (rom-0, name of the configuration file
on the ZyWALL) to the file destination on the computer and renames it config.rom.
33.3.8 GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 33-3 General Commands for GUI-based TFTP Clients

COMMAND
Host Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL's default IP address
when shipped.
Send/Fetch Use "Send" to upload the file to the ZyWALL and "Fetch" to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the ZyWALL. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to section 33.3.5 to read about configurations that disallow TFTP and FTP over WAN.
33.3.9 Backup Via Console Port
Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
33-6
DESCRIPTION
Firmware and Configuration File Maintenance