Destination-Ip - Juniper ACX7100 Quick Start Manual

[ 968.636490] ztp.py[20083]: 2021-06-09 16:47:52 INFO: ZTP: checkZTPAbort: Upgrade detected pending abort
[ 968.636697] ztp.py[20083]: 2021-06-09 16:47:52 INFO: ZTP: aborted by user config commit
[ 968.782780] ztp.py[11767]: Notice: PID found for app ztp in /var/run/pid/ztp.pid is 20083.Executing
command: (/usr/sbin/cleanzk -c /var/run/zkid/20083.id;rm /var/run/zkid/20083.id 2>/dev/null)
10. (Optional) Give the router a name. If the name includes spaces, enclose the name in quotation marks (" ").
[edit]
root@re0# set system host-name
11. Configure the default gateway.
[edit]
root@re0# set routing-options static route 0.0.0.0/0 next-hop
12. Configure the IP address and prefix length for the management port on the router.
On the ACX7100-48L, the management (MGMT) port is the upper RJ-45 port on the right side of the port panel.
[edit]
root@re0# set interfaces re0:mgmt-0 unit 0 family inet address
13. (Optional) Configure specific static routes to remote prefixes if you do not want the remote prefixes to use the
default route.
[edit]
root@re0# set routing-options static route
14. Enable Telnet service, if required.
[edit]
root@re0# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to the ACX7100-48L through Telnet using root
credentials. Root login is allowed only for SSH access.
host-name
address/prefix-length next-hop destination-ip

destination-ip

address/prefix-length
9