Connecting A Junos Space Appliance To The Network - Juniper JA2500 Junos Space Hardware Manual

JA2500 Junos Space Appliance Hardware Guide
Related
Documentation

Connecting a Junos Space Appliance to the Network

44
in Figure 12 on page 44, and an RJ-45 to DB-9 serial port adapter are supplied with the
appliance.
Figure 12: Ethernet Cable Connector
To connect the appliance to a management console, do the following:
Connect the RJ-45 to DB-9 serial port adapter to the serial port of the management
1.
device (laptop or PC) that you will use to access the Junos Space CLI.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and
you want to connect your laptop or PC directly to the appliance, use a
combination of the RJ-45 to DB-9 female adapter supplied with the
appliance and a USB to DB-9 male adapter. You must provide the USB
to DB-9 male adapter.
Connect one end of the Ethernet cable into the console port (labeled
2.
the front panel of the appliance.
Connect the other end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter.
3.
Connecting a Junos Space Appliance to the Network on page 44
Booting the Junos Space Appliance on page 47
Chassis Console Port Pinouts on page 18
Though the Junos Space Appliance has four Ethernet interfaces, only three can be used;
one of the Ethernet interface is reserved for future use. On the JA2500 appliance, the
Ethernet interfaces that can be used are labeled
reserved for future use.
For more information about Junos Space Ethernet interfaces, see
Interfaces Overview" on page
, , and
0 1
7.
Copyright © 2018, Juniper Networks, Inc.
) on
CONSOLE
. The Ethernet interface is
3 2
"Junos Space Ethernet