Planet GS-5220 Series User Manual page 375

User's Manual of GS-5220 LCD Series
• Admin State Frames sent between the supplicant and the switch are special 802.1X
frames, known as EAPOL (EAP Over LANs) frames. EAPOL frames
encapsulate EAP PDUs (RFC3748). Frames sent between the switch and
the RADIUS server are RADIUS packets. RADIUS packets also
encapsulate EAP PDUs together with other attributes like the switch's
IP address, name, and the supplicant's port number on the switch. EAP
is very flexible, in that it allows for different authentication methods,
like MD5-Challenge, PEAP, and TLS. The important thing is that the
authenticator (the switch) doesn't need to know which authentication
method the supplicant and the authentication server are using, or how
many information exchange frames are needed for a particular
method. The switch simply encapsulates the EAP part of the frame into
the relevant type (EAPOL or RADIUS) and forwards it.
When authentication is complete, the RADIUS server sends a special
packet containing a success or failure indication. Besides forwarding
this decision to the supplicant, the switch uses it to open up or block
traffic on the switch port connected to the supplicant.
Note: Suppose two backend servers are enabled and that the server
timeout is configured to X seconds (using the AAA configuration page),
and suppose that the first server in the list is currently down (but not
considered dead). Now, if the supplicant retransmits EAPOL Start
frames at a rate faster than X seconds, then it will never get
authenticated, because the switch will cancel on-going backend
authentication server requests whenever it receives a new EAPOL Start
frame from the supplicant. And since the server hasn't yet failed
(because the X seconds haven't expired), the same server will be
contacted upon the next backend authentication server request from
the switch. This scenario will loop forever. Therefore, the server
timeout should be smaller than the supplicant's EAPOL Start frame
retransmission rate.
375