Table of Contents
Advertisement
2-1-3. Cleaning the mechanical section
❶
❷
2-1-4. Cleaning the sensor
2-1-5. Cleaning the control box for the device
❸
❹
❺
– 149 –
Carry out cleaning of the mechanical section once
a twice a week.
Carry out cleaning of each belt ❶ and pulley
1)
❷ with an air gun.
In addition, carry out cleaning of moving
sections other than those shown in the figure
appropriately.
Carry out cleaning of each shaft ❸ with an air
2)
gun.
Carry out cleaning of sensor ❹ in the remain-
ing-thread removal section with an air gun once or
twice a week.
Carry out cleaning of the control box once a week.
1)
Carry out cleaning to remove dust from
around the ventilation hole on the bottom of
control box with an air gun.
2)
Carry out cleaning to remove dust gathering
in exhaust outlet ❺ of fan motor with an air
gun.
Advertisement
Table of Contents
