Ⓒ : Empty bobbin loading button
This button is used for loading an empty bobbin in the hook ❶ .
Be sure to check that the bobbin to be loaded in the hook ❶ is empty before pressing
can occur when winding the bobbin or removing the thread remaining on the bobbin.
Place an empty bobbin at bobbin case standby position ❷ and press
If no bobbin is present in hook ❶ , the empty bobbin placed as described above will be brought
•
to hook ❶ . Then, the device waits until the display is restored to the previous one and the
next bobbin is placed. The device starts winding a bobbin when
If a bobbin is already present in hook ❶ , the device will start winding of the bobbin.
•
❶
❷
Ⓒ . If a threaded bobbin is loaded in the hook ❶ , a malfunction
Ⓓ is pressed after placing the next bobbin in the hook ❶ .
– 101 –
Ⓐ : Bobbin change button
This button is used for winding a bobbin with new
thread in the case of changing the thread, etc.
When
bobbin fitted in hook ❶ is replaced by another
bobbin which is present at bobbin case standby
position ❷ . Then, the thread remaining on the
bobbin in hook ❶ is removed and new thread is
wound on the empty bobbin.
Ⓑ : Bobbin take-out button
This button is used for taking out the bobbin load-
ed in hook ❶ . Take out the bobbin that is present
at bobbin case standby position ❷ by hand before
pressing
loaded in hook ❶ is brought to bobbin case stand-
by position ❷ .
Ⓐ is pressed, the
Ⓑ . Then, when
Ⓑ is pressed, the bobbin
Ⓒ
.
Ⓒ
or