Pass nozzle thread guide tube through table hole from undersurface of the table and draw
5)
the tube until its length above the table becomes the predetermined length. Then, secure it with two
cable clip bands .
Secure wire and nozzle thread guide tube with one cable clip band . Then, secure them
with another cable clip band under the aforementioned one.
Put transparent tube over them.
Secure nozzle thread guide tube on the
6)
undersurface of the table hole with cable clip
band . At this time, it is necessary to se-
cure them while drawing nozzle thread guide
tube downward and pressing cable clip
band against the table in order to prevent
nozzle thread guide tube from rattling.
Cut off the unnecessary portion of cable clip
band .
– 7 –